I bought an Eskimo hand auger this winter and I seem to be having some trouble with it and was hoping some of you could point me in the right direction. To cut a hole, I have to put all of my weight on the auger…it just doesn’t seem like it wants to grab the ice. Is it possible that a brand new auger could have a pitch problem out of the box? The blades are sharp so I don’t think that is the problem. Anyone else have this problem?
This might seem like a stupid question but, were the blade/s installed up side down, or even back words? Believe it or not but I heard a story not a week ago about one that came with its blades installed upside down. (I think some one at the factory has a fine sence of humor, or a beef!
But once the blade were installed right it smoked holes with the best of them..
Funny that you mention that…it’s the first thing I looked at! [sly] The blades are on properly…and they cut when it catches the ice…but I really have to push down on the auger to get it to grab. I’ve used others that cut with little pressure.
LOL well like I said I was told about a situation similar to yours.
Next I’d have to think that perhaps something went wrong while the blade supportes were being welded in place. I’d take it back because it sounds like the blade pitch is wrong..
When my lazer gets dull I often have to wooble it side to side slightly to get it to bite, then it bores in fine. But I never have to apply weight to get it to bore in..
Brand new blades should cut ice like butter. It has to be something wrong from the manufacturing alignment. I would definetly take it in and trade it for another. If you have to lean on brand new blades, just think what it will be like when they start getting dull. Good luck. Fish on.