Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
eskimo shark z51 auger won't start
#1
- I have confirmed I am gettin spark.
- I have replaced the plug (gapped properly).
- Taken apart the carberator and cleaned it out.
- Replaced the primer and fuel line.
- Tested other gas to see if it was bad gas.
- I have tried pulling the plug, sprayed starting fluid in and then put the plug in and it sputter like it is going to start when I pull the crank.
- I have verified my carb is opening when I pull the trigger and open choke.

When I put starter fluid in the filter it wont sputter, like it isn't getting in to the engine.

Not sure what else it could be.

Any ideas? HELP!
[signature]
Reply


Messages In This Thread
eskimo shark z51 auger won't start - by CBR - 01-10-2012, 07:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)