+- Fishing Forum (https://bigfishtackle.com/forum)
+-- Forum: Utah Fishing Forum (https://bigfishtackle.com/forum/forumdisplay.php?fid=386)
+--- Forum: Off Topic Board (https://bigfishtackle.com/forum/forumdisplay.php?fid=112)
+--- Thread: eskimo shark z51 auger won't start (/showthread.php?tid=713745)
eskimo shark z51 auger won't start - CBR - 01-10-2012
- I have confirmed I am gettin spark.
- I have replaced the plug (gapped properly).
- Taken apart the carberator and cleaned it out.
- Replaced the primer and fuel line.
- Tested other gas to see if it was bad gas.
- I have tried pulling the plug, sprayed starting fluid in and then put the plug in and it sputter like it is going to start when I pull the crank.
- I have verified my carb is opening when I pull the trigger and open choke.
When I put starter fluid in the filter it wont sputter, like it isn't getting in to the engine.
Not sure what else it could be.
Any ideas? HELP!
[signature]
Re: [CBR] eskimo shark z51 auger won't start - sinergy - 01-11-2012
Looks like you cover all the basics Id suggest taking in and having a small engine repair shop take a look at it.
Not sure what part of the state your in but these guys have serviced my gear in the past.
A-1 Saw & Mower Service
(801) 967-1683
5433 S 4015 West,
Salt Lake City, UT 84118
[signature]
Re: [CBR] eskimo shark z51 auger won't start - GEEZER - 01-15-2012
PM sent
[signature]