# boat motor and current temps?

**URL:** <https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727>\
**Category:** Utah Fishing General\
**Created:** [April 15, 2013, 12:06pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727 "2013-04-15T12:06:32Z")\
**Posts on this page:** 7\
**Page:** 1

<div class="post-metadata">

**Author:** ![HATH](https://avatars.discourse-cdn.com/v4/letter/h/7cd45c/32.png) [@HATH](https://forum.bigfishtackle.com/u/HATH)\
**Post date:** [April 15, 2013, 12:06pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/1 "2013-04-15T12:06:32Z")

</div>

Had my boat on the lake Saturday, I didn’t run the motor to blow out any residual water and now the temp. is at or near freezing. Should I be worried of some cracked parts?

---

<div class="post-metadata">

**Author:** ![SkunkedAgain](https://yyz2.discourse-cdn.com/flex028/user_avatar/forum.bigfishtackle.com/skunkedagain/32/53758_2.png) [@SkunkedAgain](https://forum.bigfishtackle.com/u/SkunkedAgain)\
**Post date:** [April 15, 2013, 12:34pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/2 "2013-04-15T12:34:29Z")

</div>

I’m assuming its an outboard. If its like mine, I have to drop it down to run position for it to drain completely and then depending on how cold it got for how long. Usually low 20s like we had in Cache Valley Saturday night can be a problem, but outboards seem to drain out pretty well. If it is an inboard then its going to depend on cold time verses volume of water trapped. Larger volumes take a lot of cold to freeze, but when they do they can do a lot of damage. Good luck. J

---

<div class="post-metadata">

**Author:** ![Kent](https://avatars.discourse-cdn.com/v4/letter/k/b782af/32.png) [@Kent](https://forum.bigfishtackle.com/u/Kent)\
**Post date:** [April 15, 2013, 12:44pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/3 "2013-04-15T12:44:31Z")

</div>

Yes

---

<div class="post-metadata">

**Author:** ![HATH](https://avatars.discourse-cdn.com/v4/letter/h/7cd45c/32.png) [@HATH](https://forum.bigfishtackle.com/u/HATH)\
**Post date:** [April 15, 2013, 12:55pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/4 "2013-04-15T12:55:13Z")

</div>

It is an outboard and when I parked it I did trim the motor down to where it would be if I was running it in the water. I’m in Utah county so luckily it didn’t get in the twenties, in fact, I’m not sure if we even hit 32 degrees, it was close though, but when I woke up to a little bit of snow I started worrying. I didn’t even think about blowing the water out since the weather has been so good.

---

<div class="post-metadata">

**Author:** ![HATH](https://avatars.discourse-cdn.com/v4/letter/h/7cd45c/32.png) [@HATH](https://forum.bigfishtackle.com/u/HATH)\
**Post date:** [April 15, 2013, 12:59pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/5 "2013-04-15T12:59:12Z")

</div>

If damage has occurred, how do I test it? Hook the dog ears up and run it…any abnormalities would mean theres a problem? Sorry for stating the obvious, or am I going to physically see say water coming from the block?

---

<div class="post-metadata">

**Author:** ![Kent](https://avatars.discourse-cdn.com/v4/letter/k/b782af/32.png) [@Kent](https://forum.bigfishtackle.com/u/Kent)\
**Post date:** [April 15, 2013, 1:29pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/6 "2013-04-15T13:29:21Z")

</div>

Sorry, but when it happened to me it was obvious, just by looking at the lower unit, that there was something seriously wrong.

---

<div class="post-metadata">

**Author:** ![HATH](https://avatars.discourse-cdn.com/v4/letter/h/7cd45c/32.png) [@HATH](https://forum.bigfishtackle.com/u/HATH)\
**Post date:** [April 16, 2013, 1:17pm UTC](https://forum.bigfishtackle.com/t/boat-motor-and-current-temps/219727/7 "2013-04-16T13:17:21Z")

</div>

Well I went and hooked the dog ears up to the motor and ran it last night. Everything seemed fine. Once I was done with the hose I made sure to blow the excess water out, as George W Junior said “Fool me once shame… fool me twice…we just won’t be fooled”🕶

[![](https://canada1.discourse-cdn.com/flex028/uploads/bigfishtackle/original/3X/e/b/ebf965ef56d2b2b64d7a132700e799f09d2164d1.jpeg "George Bush's "Fool Me Once" Gaffe") ](https://www.youtube.com/watch?v=KjmjqlOPd6A)
