08-20-2014, 07:44 PM
Mount the transducer per mfr. instructions. To run the cable, I'd drill a hole just barely big enough to accommodate the cable plug. Drill the hole as close to directly above the transducer as possible. I'd suggest drilling it in the brown area on the transom at least 12" above where you'd ever expect water to reach. You can seal the hole with any good quality silicone sealer. If cosmetics are important, you may be able to buy a brown silicone that comes close to matching your boat. Get two or three small plastic, or rubber coated stainless steel cable clips to secure the exposed cable to the transom and you're in business.
[signature]
[signature]