Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
transducer mount on aluminum boat
#5
I don't drill holes in my boat either. I use the 3M 4200 (faster curing than 5200) adhesive. I simply buy a cheap cutting board from Wal-mart and then use a hack saw to cut it to the size I need. I glue that onto my boat and then mount my transducer with 1/2" stainless screws onto the cutting board. It is cheaper to use the cutting board than to buy a "transducer mount board" from Cabelas or Bass Pro. I've had mine on for YEARS in both extreme cold/ice and in heat and the board or transducers have NEVER came off. Even cruising at 45 mph the 3M 4200 holds like no other.
[signature]
Reply


Messages In This Thread
transducer mount on aluminum boat - by fmrusmc - 06-16-2014, 10:11 PM
Re: [fmrusmc] transducer mount on aluminum boat - by BearLakeFishGuy - 06-17-2014, 10:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)