01-18-2014, 01:13 AM
[quote JoyRide]I apologize if this post shows up twice. It seemed to disappear when I first posted.
I need a bit of help installing the carb (Tillotsen HU series?) for my Auger head. The power head appears to be a 49cc Tecumseh TC 300 3106D.
I believe I have all the holes lined up correctly from the carb through the spacer to the engine intake. My problem seems to be with hooking up the accelerator spring from the accelerator slide to the carb and the placement of the blade on the end of the carb accelerator shaft. I know where the spring hooks up to the slide that attaches to the accelerator handle through the cable, but don't see where it hooks up to the carburetor. I also don't know what the blade on the end of the carb shaft does or where it is supposed to be placed.
Clear as mud eh?
Any help?[/quote]
This is my first post. I just set up my TC300 and needed this file to get the air gap in the flywheel. Hope this helps. The vane diagrams are about half way down the page.
Glen
http://scia.rrvsd.ca/pdf/Links/TC%20Seri...ngines.pdf
[signature]
I need a bit of help installing the carb (Tillotsen HU series?) for my Auger head. The power head appears to be a 49cc Tecumseh TC 300 3106D.
I believe I have all the holes lined up correctly from the carb through the spacer to the engine intake. My problem seems to be with hooking up the accelerator spring from the accelerator slide to the carb and the placement of the blade on the end of the carb accelerator shaft. I know where the spring hooks up to the slide that attaches to the accelerator handle through the cable, but don't see where it hooks up to the carburetor. I also don't know what the blade on the end of the carb shaft does or where it is supposed to be placed.
Clear as mud eh?
Any help?[/quote]
This is my first post. I just set up my TC300 and needed this file to get the air gap in the flywheel. Hope this helps. The vane diagrams are about half way down the page.
Glen
http://scia.rrvsd.ca/pdf/Links/TC%20Seri...ngines.pdf
[signature]