Tax time!

[Oskolkoff]

my next one is going to be 10ft outcast tubes and i am going to make my own frame bend and weld it up out of inch and half aluminum tubing and a platform on the back for a battery and a trolling motor a word of warning about bucks bags frames i had a older southfork with a steel frame and the weld were crap to say the least they were cracking and the tubing was paper thin like 20ga i would not buy a bucks bags again i was not impressed at all with it ended up sinking it on indain creek after a couple weld broke in the middle of the first rapid end up having to body float down to kuna i was all cut up by the time i got off the creek it is just a bad design the part of the frame that sits on the pontoon welds to the part you sit on all the stress is on the welds and the tubing is to thin for that look at cataraft frames they need to be more like that
[signature]