Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Auger of Choice
#17
[quote Fishooker] I figure it's rated to -20 or something like that, and when it's already freezing out, the wind chill factor from riding in the back of the truck might cool it off quite a bit. Anyway, that's just what I do. I have left the propane in the back and still had it start just fine. I think it has many advantages over gas powered augers, but in the end..it cuts a hole, and that's what counts.[/quote]

Wind chill does not affect inanimate objects. If it's 0° outside, then the propane will cool to 0°. It will not get any colder than that.
[signature]
Reply


Messages In This Thread
Auger of Choice - by bmitchell - 12-29-2011, 09:05 PM
Re: [bmitchell] Auger of Choice - by hookngrinin - 12-29-2011, 09:29 PM
Re: [bmitchell] Auger of Choice - by Fishsticker - 12-29-2011, 10:07 PM
Re: [bmitchell] Auger of Choice - by bigfish22 - 12-29-2011, 10:34 PM
Re: [bmitchell] Auger of Choice - by sinergy - 12-29-2011, 10:49 PM
Re: [sinergy] Auger of Choice - by Trackerg - 12-29-2011, 11:10 PM
Re: [Trackerg] Auger of Choice - by Trackerg - 12-29-2011, 11:12 PM
Re: [bmitchell] Auger of Choice - by k2muskie - 12-29-2011, 11:00 PM
Re: [k2muskie] Auger of Choice - by PACKFAN - 12-30-2011, 01:14 AM
Re: [MichiganAngler] Auger of Choice - by stan55 - 12-30-2011, 12:05 AM
Re: [bmitchell] Auger of Choice - by SEETSNFR - 12-30-2011, 12:25 AM
Re: [bmitchell] Auger of Choice - by Fin-Addict - 12-30-2011, 01:29 AM
Re: [bmitchell] Auger of Choice - by Fishooker - 01-05-2012, 03:32 AM
Re: [Fishooker] Auger of Choice - by Fishrmn - 01-05-2012, 04:08 AM
Re: [Fishrmn] Auger of Choice - by Fishooker - 01-05-2012, 05:40 AM
Re: [Fishooker] Auger of Choice - by Fishrmn - 01-05-2012, 02:20 PM
Re: [bmitchell] Auger of Choice - by yortmac - 01-05-2012, 04:04 AM
Re: [bmitchell] Auger of Choice - by perchski - 01-05-2012, 03:59 PM
Re: [perchski] Auger of Choice - by bmitchell - 01-05-2012, 04:02 PM
Re: [bmitchell] Auger of Choice - by perchski - 01-05-2012, 04:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)