09-10-2011, 12:42 AM
So I had a piece of thicker aluminum sheet that I cut last night and fitted to my rig. I made the new deck as wide as I could which is about half again as wide as the deck that came with the rig. Since I have my seat all the way back it takes up about 1/4 of the deck anyways.
Once I got the hole cut, pipe installed and wheel set up I realized that my wheel was to small and I had to push the boat hunched over or the pontoons hit the ground. So today I hit KSL and found 2 part bikes for $5.00, picked them up and rigged the new tire which works way better but it is a tippy ride.
Had to remount my rear fishing rod holders onto the deck instead of on the frame, drilled an extra hole in the foot pegs so I can move them out as far as possible, (some times it sucks being 6'10" tall) and got my fish finder installed and plumbed.
Look out Willard because I am there in the morning.
Thanks for all the tips guys, this site rocks.
[signature]
Once I got the hole cut, pipe installed and wheel set up I realized that my wheel was to small and I had to push the boat hunched over or the pontoons hit the ground. So today I hit KSL and found 2 part bikes for $5.00, picked them up and rigged the new tire which works way better but it is a tippy ride.
Had to remount my rear fishing rod holders onto the deck instead of on the frame, drilled an extra hole in the foot pegs so I can move them out as far as possible, (some times it sucks being 6'10" tall) and got my fish finder installed and plumbed.
Look out Willard because I am there in the morning.
Thanks for all the tips guys, this site rocks.
[signature]