Quick Draw Rod Holder

[TubeDude]

[cool][#0000ff]If you do make the 1", you might try what I did to keep it as close as possible to a good fit. Use PVC cement to glue in some 1" pieces of type 200 1" PVC before you make your cuts. That will reduce the inside diameter a bit and if you do a good glue job the inserts will stick through the cutting...and while in use later.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Lots of different kinds of rod handles. And a 1" handle is not always exactly 1". Keeps us PVC perverts on our toes to keep up with it all.[/#0000ff]
[signature]