09-01-2011, 11:30 PM
[cool][#0000ff]Two suggestions. 1...use your Dremel tool to cut away a little bit of the 3/4" fitting on the inside. 2...make an alternate set with 1" fittings for the larger rods. If you have them set up for quick install and removal they are interchangeable.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]One other note. If you are propping them up at an angle you might as well just use a PVC tube. The quick draw is designed to be used for holding the rods almost horizontal over the water.[/#0000ff]
[signature]
[#0000ff][/#0000ff]
[#0000ff]One other note. If you are propping them up at an angle you might as well just use a PVC tube. The quick draw is designed to be used for holding the rods almost horizontal over the water.[/#0000ff]
[signature]