09-01-2011, 11:53 AM
[quote h82sink]You could potentially make more than one notch so the holder could be at different angles providing it didn't have an adverse affect on the strength of the PVC.[/quote]
[cool][#0000ff]That is something I considered but after getting the positions set precisely where I want them I found no need for other slots. But, unless you made the slots very close to each other there would not likely be any problem with strength. PVC is quite strong and it would be almost impossible for a mere fish to put enough torque on the holder to break it.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Another option is to cut the groove in the fitting at the bottom and put the screw into the shaft on the holder. It works as well but not as smooth and clean.[/#0000ff]
[signature]
[cool][#0000ff]That is something I considered but after getting the positions set precisely where I want them I found no need for other slots. But, unless you made the slots very close to each other there would not likely be any problem with strength. PVC is quite strong and it would be almost impossible for a mere fish to put enough torque on the holder to break it.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Another option is to cut the groove in the fitting at the bottom and put the screw into the shaft on the holder. It works as well but not as smooth and clean.[/#0000ff]
[signature]