10-15-2010, 12:58 PM
What did you end up doing on this? Was it harder/easier than you thought? Are you satisfied with the way it turned out? Any changes you would have made (if any)? You should post a picture or two of it.
Not sure if your boat had this, but how do you deal with stripped or screws that seem to be rusted? All of the screws on my floor strip out when I try to unscrew them & I'm using the right sizes and even strip when I try to loosen them by hand.
[signature]
Not sure if your boat had this, but how do you deal with stripped or screws that seem to be rusted? All of the screws on my floor strip out when I try to unscrew them & I'm using the right sizes and even strip when I try to loosen them by hand.
[signature]