06-23-2010, 01:45 PM
It is Dave Scadden apron. What I did is rigid up the front
by inserting a piece of aluminum inside.
Then I removed the piece of foam from the rear. Installed
quick release clips up front and made those straps for
the oar towers.
Rear attachment to lean bar is only on the left side
for now. Because that is where my line goes (left side).
I'm not sure if I'm going to do the right rear as well.
I need to take it out on the water and test it.
Size of apron 26''x17''. It is large witch I like.
When I fold it , It is very small. I put it between the left packet and oar tower/oar holder. Fits in there very nicely.
Hope this helps.
Peter
[signature]
by inserting a piece of aluminum inside.
Then I removed the piece of foam from the rear. Installed
quick release clips up front and made those straps for
the oar towers.
Rear attachment to lean bar is only on the left side
for now. Because that is where my line goes (left side).
I'm not sure if I'm going to do the right rear as well.
I need to take it out on the water and test it.
Size of apron 26''x17''. It is large witch I like.
When I fold it , It is very small. I put it between the left packet and oar tower/oar holder. Fits in there very nicely.
Hope this helps.
Peter
[signature]