06-12-2010, 07:23 PM
[quote pa]I agree bout the seat area on the FC4. I take my foam out and let it dry good before I put it back in. If memory serves me right. the water temp. at the cleaning stations is at least
140 degrees. Do you think that temp. could damage the foam or anything else on a tube?
pa[/quote]
[cool][#0000ff]The specs for most foams used in construction or floatation devices list the melting points at above 250 degrees F. Considerably below the potential temps of a decontamination wash.[/#0000ff]
[signature]
140 degrees. Do you think that temp. could damage the foam or anything else on a tube?
pa[/quote]
[cool][#0000ff]The specs for most foams used in construction or floatation devices list the melting points at above 250 degrees F. Considerably below the potential temps of a decontamination wash.[/#0000ff]
[signature]