Fishing Forum › Float Tube Fishing › Float Tubing General v
Motors

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Motors
cpierce Offline
Channel Catfish
*********
Posts: 5,277
Threads: 0
Joined: Aug 2009
Reputation: 0
#6
06-12-2010, 05:11 PM
I don't think it will damage the material, but then too I haven't tried!

I would definitely reduce the air in the bladders of a tube or pontoon boat before washing in hot water. Otherwise the warmth will expand the air in them and you may have a burst bladder.
[signature]
Find
Reply


Messages In This Thread
Motors - by flygoddess - 06-12-2010, 02:09 PM
Re: [flygoddess] Motors - by TubeDude - 06-12-2010, 03:34 PM
Re: [TubeDude] Motors - by flygoddess - 06-12-2010, 03:44 PM
Re: [flygoddess] Motors - by cpierce - 06-12-2010, 04:46 PM
Re: [cpierce] Motors - by pa - 06-12-2010, 04:55 PM
Re: [pa] Motors - by cpierce - 06-12-2010, 05:11 PM
Re: [pa] Motors - by flygoddess - 06-12-2010, 05:17 PM
Re: [pa] Motors - by TubeDude - 06-12-2010, 07:23 PM
Re: [TubeDude] Motors - by idahoron - 06-12-2010, 09:48 PM
Re: [cpierce] Motors - by mojorizing - 06-12-2010, 06:03 PM
Re: [TubeDude] Motors - by albinotrout - 06-13-2010, 01:51 AM
Re: [albinotrout] Motors - by flygoddess - 06-13-2010, 02:02 AM
Re: [flygoddess] Motors - by idahoron - 06-13-2010, 03:49 PM
Re: [idahoron] Motors - by flygoddess - 06-13-2010, 06:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)