Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tube Taxi and Kitties
#8
[quote TubeDude]
[#0000ff]BUT...that is not possible with the FLOAT POWER, as you pointed out. Since the motor extends down into the water you gotta take it out a ways to get launched. Guess that is ONE of the reasons why I never got one.[/#0000ff]
[/quote]

After my first run with the Float Power, I am already wishing I had your setup. I will see if I can return it and look for a used U shape tube. Aside from the motor extending down, it is also a tight fit to put the motor and battery through the small donut hole. Combined that with the weight of the motor and battery, it is a two man job really.

[quote TubeDude]
[#0000ff]I have a few more tweaks on the system to make after the shakedown cruise. Then I will post a complete pictorial on the system...including the simple but effective frame (PVC...what else?) that holds both the motor and battery.[/#0000ff] [/quote]

I can't wait for this. And if I do swap the Float Power for another U shaped tube, I am sure I may need a visit to the tubetorium for some help on putting this together.
[signature]
Reply


Messages In This Thread
Tube Taxi and Kitties - by TubeDude - 04-26-2010, 11:57 PM
Re: [TubeDude] Tube Taxi and Kitties - by dr.veha - 04-27-2010, 01:41 PM
Re: [dr.veha] Tube Taxi and Kitties - by TubeDude - 04-27-2010, 03:13 PM
Re: [TubeDude] Tube Taxi and Kitties - by dr.veha - 04-27-2010, 04:08 PM
Re: [dr.veha] Tube Taxi and Kitties - by TubeDude - 04-27-2010, 04:16 PM
Re: [TubeDude] Tube Taxi and Kitties - by dr.veha - 04-27-2010, 03:34 AM
Re: [dr.veha] Tube Taxi and Kitties - by TubeDude - 04-27-2010, 12:58 PM
Re: [TubeDude] Tube Taxi and Kitties - by wagdog - 04-27-2010, 03:45 PM
Re: [wagdog] Tube Taxi and Kitties - by TubeDude - 04-27-2010, 04:13 PM
Re: [TubeDude] Tube Taxi and Kitties - by crawfly - 04-28-2010, 07:25 PM
Re: [crawfly] Tube Taxi and Kitties - by TubeDude - 04-28-2010, 08:24 PM
Re: [TubeDude] Tube Taxi and Kitties - by crawfly - 04-28-2010, 09:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)