Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New SteelHead setup
#17
[quote STEELHEADKID]The GL2 is a hunk of junk, for the price of a gl2 you can get a far better rod for the money. However the gl3 and IMX are where its at. I've owned and still do own all of the above and would never waste my money on a new gl2, I'd have a custom rainshadow built for the same price.[/quote]

Besides flaming people and their equipment, I don't think you would know the difference between a good rod and a bad one. If you think the GL2 is a hunk of junk, and I own over 40 Loomis rods you probably don't understand that each rod has its strength and reason for use. Knowing which rod to pull and when might be a thing. [Image: bobwink.gif]
[signature]
Reply


Messages In This Thread
New SteelHead setup - by prvrt - 03-25-2010, 04:58 AM
Re: [prvrt] New SteelHead setup - by tob04002 - 03-25-2010, 05:15 AM
Re: [prvrt] New SteelHead setup - by chrome_junky - 03-25-2010, 07:01 AM
Re: [chrome_junky] New SteelHead setup - by prvrt - 03-25-2010, 11:15 AM
Re: [prvrt] New SteelHead setup - by chrome_junky - 03-25-2010, 04:52 PM
Re: [STEELHEADKID] New SteelHead setup - by jigs - 03-26-2010, 12:48 AM
Re: [jigs] New SteelHead setup - by prvrt - 03-26-2010, 12:53 AM
Re: [prvrt] New SteelHead setup - by jigs - 03-26-2010, 12:58 AM
Re: [jigs] New SteelHead setup - by prvrt - 03-26-2010, 01:15 AM
Re: [STEELHEADKID] New SteelHead setup - by MMDon - 03-26-2010, 02:21 AM
Re: [MMDon] New SteelHead setup - by STEELHEADKID - 03-26-2010, 02:37 AM
Re: [Belasko] New SteelHead setup - by prvrt - 03-26-2010, 03:18 AM
Re: [prvrt] New SteelHead setup - by MMDon - 03-26-2010, 03:20 AM
Re: [MMDon] New SteelHead setup - by prvrt - 03-29-2010, 04:17 AM
Re: [prvrt] New SteelHead setup - by jimpete525 - 03-29-2010, 04:41 AM
Re: [jimpete525] New SteelHead setup - by prvrt - 03-30-2010, 03:20 AM
Re: [prvrt] New SteelHead setup - by tob04002 - 03-30-2010, 03:53 AM
Re: [SteelFan] New SteelHead setup - by stlhdr208 - 03-26-2010, 02:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)