Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New SteelHead setup
#4
I will be tenting it again when I go up. I went with the GL3 for 2 reasons. One is after holding both and playing with them for about an hour, the GL2 seemed more like a wet noodle compared to the GL3. The GL2 would flex quite a bit from the tip down about 3'-4'. The GL3 only flexed about the top 18" and felt like it had a little more backbone and would be a little easier to cast and control. The second reason is the GF bought me the reel so I had enough to buy the rod that I felt would work the best and felt the best in my hands. I really was only after a Fenwick, but Sportman's was out of them, so I figured no sense in putting a nice reel on a cheap pole.

I will be fishing the same place again. Look for a Pewter 96' MAV. No sticker on it as it is the GF's.
[signature]
Reply


Messages In This Thread
New SteelHead setup - by prvrt - 03-25-2010, 04:58 AM
Re: [prvrt] New SteelHead setup - by tob04002 - 03-25-2010, 05:15 AM
Re: [prvrt] New SteelHead setup - by chrome_junky - 03-25-2010, 07:01 AM
Re: [chrome_junky] New SteelHead setup - by prvrt - 03-25-2010, 11:15 AM
Re: [prvrt] New SteelHead setup - by chrome_junky - 03-25-2010, 04:52 PM
Re: [STEELHEADKID] New SteelHead setup - by jigs - 03-26-2010, 12:48 AM
Re: [jigs] New SteelHead setup - by prvrt - 03-26-2010, 12:53 AM
Re: [prvrt] New SteelHead setup - by jigs - 03-26-2010, 12:58 AM
Re: [jigs] New SteelHead setup - by prvrt - 03-26-2010, 01:15 AM
Re: [STEELHEADKID] New SteelHead setup - by MMDon - 03-26-2010, 02:21 AM
Re: [MMDon] New SteelHead setup - by STEELHEADKID - 03-26-2010, 02:37 AM
Re: [Belasko] New SteelHead setup - by prvrt - 03-26-2010, 03:18 AM
Re: [prvrt] New SteelHead setup - by MMDon - 03-26-2010, 03:20 AM
Re: [MMDon] New SteelHead setup - by prvrt - 03-29-2010, 04:17 AM
Re: [prvrt] New SteelHead setup - by jimpete525 - 03-29-2010, 04:41 AM
Re: [jimpete525] New SteelHead setup - by prvrt - 03-30-2010, 03:20 AM
Re: [prvrt] New SteelHead setup - by tob04002 - 03-30-2010, 03:53 AM
Re: [SteelFan] New SteelHead setup - by stlhdr208 - 03-26-2010, 02:42 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)