08-30-2009, 07:08 PM
Well here it is the Cuda 300, install is complete on my Togiak's rod rack.
I wanted the transducer to pivot so launching and landing could be done with out removing the transducer. So I simply cut a slot and did the screw this for the stop.
See my rod rack post for details.
Well here are the picture.
[signature]
I wanted the transducer to pivot so launching and landing could be done with out removing the transducer. So I simply cut a slot and did the screw this for the stop.
See my rod rack post for details.
Well here are the picture.
[signature]