07-20-2009, 07:48 PM
[cool][#0000ff]Those should work very well. I briefly tried some of those, by running a long steel rod across as an axle. It tended to hang up a lot on rocks, etc. However, if you rig it with a short rod, like I have for the golf cart wheels on a straight shaft, they will work better. I did try that on one model (no pics) and drilled holes through the shaft and used cotter pins to hold it in place. Okay, but a bit wobbly...even with washers. The nut and bolt setup works much better. Only problem is that the rough surface on that rod will wear out the nylon surface on the wheel.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Good luck.[/#0000ff]
[signature]
[#0000ff][/#0000ff]
[#0000ff]Good luck.[/#0000ff]
[signature]
