Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First Post - Sayin Hi
#7
[quote flygoddess] and if it is a really warm day, you might want to put the tube in the water for several minutes then check the air again.[/quote]

What's the reason for this? Will the tube lose a little pressure after it's been in the water? I'm curious because I went out again this evening - it was about 80 - 85. When I put the tube in the water it was fully inflated. When I came back in - about 2 1/2 hours later - it seemed to have lost a little bit of pressure. Naturally I started to worry that I might have a leak in one of the tubes - and after only 3 times out. I'm hoping that I just didn't close one of the nozzles all the way.
[signature]
Reply


Messages In This Thread
First Post - Sayin Hi - by jrod106 - 07-18-2009, 12:57 AM
Re: [flygoddess] First Post - Sayin Hi - by jrod106 - 07-20-2009, 01:53 AM
Re: [jrod106] First Post - Sayin Hi - by TubeDude - 07-20-2009, 12:06 PM
Re: [jrod106] First Post - Sayin Hi - by peter805 - 07-18-2009, 04:54 AM
Re: [jrod106] First Post - Sayin Hi - by BigBo - 07-19-2009, 12:34 AM
Re: [jrod106] First Post - Sayin Hi - by TubeDude - 07-19-2009, 12:40 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)