07-02-2009, 03:18 AM
Pretty close on the tools that I used! I did start out with a 1/2 router bit but had to go to a 3/4, and a warning to everyone else, that pvc really grabs ahold to a router bit, be sure you have a good hold, and your hand in a safe spot. A miter saw for the ends. As far as the slots go, I do quite a bit of trolling,even only having oars, I feel that the added action of rowing does good stuff at times. But with trolling the angle of a fish hitting is more straight out the back rather than a downward pull, not too mention swapping back and forth between rods sometimes you don't get them seated as well as you might of hoped, hence the slots in the holder. I have a substantial investment in rods and reels, and don't want to watch them sink!
[signature]
[signature]