01-26-2009, 06:55 PM
The brass air tube attached to a truck inner usually has a 90 degree bend about 2" from the tube.
If there is none, you can make a bend with two pairs of visegrips, or better, a bench vise and a visegrips.
While deflated it's not tight and you can twist/rotate the brass tube so it comes out of the bladder towards you (where you will sit) then turns along the zipper line of the tube cover.
The zipper overlaps for a bit, and the brass airtube lies in that spot.
Hope this is clear enough.
[signature]
If there is none, you can make a bend with two pairs of visegrips, or better, a bench vise and a visegrips.
While deflated it's not tight and you can twist/rotate the brass tube so it comes out of the bladder towards you (where you will sit) then turns along the zipper line of the tube cover.
The zipper overlaps for a bit, and the brass airtube lies in that spot.
Hope this is clear enough.
[signature]