Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lead
#11
Some bad info about lead here. Sources? Older style wheel weights (new ones are zinc, bad news...) Spent bullets from backstop at a range, old lead pipes or sheathing. Alloyed lead like the wheel weights contains some antimony and tin, makes it fill in details better than pure soft lead, weighs a little less and melts at a lower temperature. Pure soft lead melts at a much higher temp and unless the metal and mold are up to temperature, it will produce a wrinkled casting. Do not reclaim lead from a car battery. If the dross is exposed to moisture, arsine gas is formed and it is a poison. Scrap yards sometimes have lead in various forms, metal prices are at an all time high, good luck. For more info, Google bullet casting....those guys know how to deal with lead and its various alloys.
[signature]
Reply


Messages In This Thread
Lead - by Out4aFloat - 03-19-2008, 07:27 PM
Re: [Out4aFloat] Lead - by Saberfish - 03-19-2008, 09:28 PM
Re: [Out4aFloat] Lead - by beerbattered - 03-27-2008, 01:26 AM
Re: [Out4aFloat] Lead - by TubeDude - 03-30-2008, 05:52 PM
Re: [TubeDude] Lead - by Out4aFloat - 04-01-2008, 03:03 PM
Re: [Out4aFloat] Lead - by TubeDude - 04-01-2008, 05:35 PM
Re: [Out4aFloat] Lead - by mactuna - 04-03-2008, 12:37 PM
Re: [mactuna] Lead - by Out4aFloat - 04-06-2008, 02:41 AM
Re: [Out4aFloat] Lead - by Straick - 05-04-2008, 12:40 AM
Re: [Straick] Lead - by TubeDude - 05-14-2008, 12:27 PM
Re: [TubeDude] Lead - by TontoG - 08-12-2008, 01:21 AM
Re: [TontoG] Lead - by papabear47 - 08-17-2008, 09:12 PM
Re: [TontoG] Lead - by TubeDude - 08-27-2008, 05:38 PM
Re: [TubeDude] Lead - by TontoG - 08-28-2008, 10:46 AM
Re: [mactuna] Lead - by papabear47 - 08-17-2008, 09:20 PM
Re: [papabear47] Lead - by mactuna - 08-18-2008, 07:32 PM
Re: [Out4aFloat] Lead - by Illinoisgiller - 02-02-2009, 02:24 AM
Re: [Out4aFloat] Lead - by Carp_Punisher - 07-11-2009, 01:40 AM
Re: [Carp_Punisher] Lead - by roadking98 - 03-24-2010, 01:41 AM
Re: [roadking98] Lead - by DocCrappie - 03-29-2010, 01:03 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)