04-07-2003, 11:01 PM
in addition to [url "http://www.bigfishtackle.com/cgi-bin/gforum/gforum.cgi?username=Curtisfish;"]Curtisfish[size 1] [/size][/url] was saying about the diaphram in the carb deprie floating around in side of the carb housing can cause simillar conditions. to check if this is the posible problem close the valve screws all the way then take them compleatly out pump your ball to flush out any posible sediments out the valves.
then inspect valve screws for rust or tarnish clean aproperatly screw the valve screws back in all the way (do not seet-over tighten) then return to factory pre-set recomended ajustmints.
especialy in older modles bleeading of the carb is a good thing. and may save you countless numbers of hours of lost performance time due to unscedualed maintainance
[signature]
then inspect valve screws for rust or tarnish clean aproperatly screw the valve screws back in all the way (do not seet-over tighten) then return to factory pre-set recomended ajustmints.
especialy in older modles bleeading of the carb is a good thing. and may save you countless numbers of hours of lost performance time due to unscedualed maintainance
[signature]