05-15-2007, 06:26 PM
Saberfish, I do use Knot Sense and I use it a lot. I use it on all my line leader conections (nail knot, needle knot, and line loop) to smooth it out so it will go throught the guides easier. I also put a dot on my camo intermediate at 30' so I know where I am when stripping it in.
A little note I found out....if you put some knot sense on something and think you have put a little too much on or it formed a bubble a little bigger than you want, use a hair dryer to smooth it out. This is before you put it in the UV light or sun....haven't tried this after it is set up yet.
I also have the little UV flash light put out by LOON, Need batteries now but still got it for quick set-ups.
Never used it on flies, I just use ply-bond, or two stage epoxy.
[signature]
A little note I found out....if you put some knot sense on something and think you have put a little too much on or it formed a bubble a little bigger than you want, use a hair dryer to smooth it out. This is before you put it in the UV light or sun....haven't tried this after it is set up yet.
I also have the little UV flash light put out by LOON, Need batteries now but still got it for quick set-ups.
Never used it on flies, I just use ply-bond, or two stage epoxy.
[signature]