05-15-2007, 05:06 PM
If the thread wrapped base of the shank is exposed you might try using zap agap to glue a piece of the mono material to the entire length of the shank. I would rough up the mono material for the lengths that will be glued to the shank.
Wipe the surface down with alcohol after roughing it up. Wait for the alcohol to completely dry before. Keep your greasy fingers off all surfaces.
That might work.
I know a guy that uses zap a gap to glue leaders to his fly line without using any knot of any kind. Says he has never had one come apart so it might work in this application.
[signature]
Wipe the surface down with alcohol after roughing it up. Wait for the alcohol to completely dry before. Keep your greasy fingers off all surfaces.
That might work.
I know a guy that uses zap a gap to glue leaders to his fly line without using any knot of any kind. Says he has never had one come apart so it might work in this application.
[signature]