Fishing Forum › Misc. Fishing Forums › Lure & Jig Making v
Finishing the spinner

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Finishing the spinner
TubeDude Offline
Shark
**********
Posts: 36,172
Threads: 307
Joined: Sep 2002
Reputation: 62
#10
12-03-2006, 01:16 AM
[cool][#0000ff]Should be fairly easy. Heat the blade over some kind of heat source. Sprinkle on some powder paint and let it adhere to the surface. Then, put the blade into a toaster oven or something and heat to about 150 for several minutes. That finishes melting the powder to the metal and "cures" it.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]If you are careful to keep up the convex side, you shouldn't have to worry about masking it off. The masking tape would probably also melt.[/#0000ff]
[signature]
Find
Reply


Messages In This Thread
Finishing the spinner - by bdn06 - 12-01-2006, 07:17 PM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-02-2006, 01:23 PM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-02-2006, 02:06 PM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-02-2006, 04:09 PM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-02-2006, 09:25 PM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-02-2006, 09:38 PM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-02-2006, 11:06 PM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-02-2006, 11:52 PM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-03-2006, 12:19 AM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-03-2006, 01:16 AM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-03-2006, 01:55 AM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-03-2006, 03:02 AM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-03-2006, 01:24 PM
Re: [TubeDude] Finishing the spinner - by bdn06 - 12-03-2006, 02:04 PM
Re: [bdn06] Finishing the spinner - by TubeDude - 12-03-2006, 02:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)