|
Fly tying station suggestions ?
|
11-05-2006, 05:50 PM
I am always worried about spilling the head cement because it will make a mess you can not completely clean up. So I have used foam or styrofoam to make a base for the the bottles. Use a sharpie or pen to trace around a bottle then use an xacto knife to cutout a hole slightly smaller than the bottle.
![[Image: HeadCement.jpg]](http://i46.photobucket.com/albums/f150/SnapShotter/HeadCement.jpg) [signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fly tying station suggestions ? - by Fishhound - 11-04-2006, 11:44 PM
Re: [Fishhound] Fly tying station suggestions ? - by Scruffy_Fly - 11-05-2006, 01:30 AM
Re: [Scruffy_Fly] Fly tying station suggestions ? - by Fishhound - 11-05-2006, 11:16 AM
Re: [Fishhound] Fly tying station suggestions ? - by Dryrod - 11-05-2006, 02:16 AM
Re: [Dryrod] Fly tying station suggestions ? - by Fishhound - 11-05-2006, 11:27 AM
Re: [Fishhound] Fly tying station suggestions ? - by Dryrod - 11-05-2006, 04:16 PM
Re: [Fishhound] Fly tying station suggestions ? - by Scruffy_Fly - 11-05-2006, 05:50 PM
Re: [Scruffy_Fly] Fly tying station suggestions ? - by Fishhound - 11-09-2006, 02:15 PM
Re: [Fishhound] Fly tying station suggestions ? - by Scruffy_Fly - 11-09-2006, 03:02 PM
|
