03-25-2005, 08:36 PM
[cool][#0000ff]The drink holder is not holding the display itself, but a piece of 2" PVC Pipe, upon which I mounted the base plate and into which I stuffed the extra transducer wire (so I didn't have to cut and splice).[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]I suspect that you could cut a piece of wood, plastic or almost anything to serve as the base mount, just big enough to stuff into the drink holder. Once you have the base plate mounted, you are good to go.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Here's a bigger pic of the pocket mount arrangement. It is small in the other post. As you can see, the main idea is to get something that fits inside the pocket...snug but easy to get in and out.[/#0000ff]
[signature]
[#0000ff][/#0000ff]
[#0000ff]I suspect that you could cut a piece of wood, plastic or almost anything to serve as the base mount, just big enough to stuff into the drink holder. Once you have the base plate mounted, you are good to go.[/#0000ff]
[#0000ff][/#0000ff]
[#0000ff]Here's a bigger pic of the pocket mount arrangement. It is small in the other post. As you can see, the main idea is to get something that fits inside the pocket...snug but easy to get in and out.[/#0000ff]
[signature]