02-22-2005, 04:33 AM
Welcome to the board. I have the same toon as you are looking at, I used it last summer and liked and learned alot with it. There are three problems I have had.
1- There is a wear point on the bottom where the two seams are sewen together. My seams were wearing from dragging my toon in and out of my truck. I put duct tape over the seams and this helped.
2- With the motor mount offset to the right I had to use a longer shaft motor so I wouldn't hit the r/hand pontoon.
3- The valves will sometimes develope a slow leak ( not enough to worrie about in four hours of fishing ) I'm going to put o-rings or thin cork strips in the caps and see if that helps.
I learned alot from that toon to help me upgrade. I now use a fish cat cougar and like it alot.
If you have any questions ask away or p.m. me.
Rodger
p.s. If I can fix the valve problem, I will be selling it in april. That toon has many fish storys
[signature]
1- There is a wear point on the bottom where the two seams are sewen together. My seams were wearing from dragging my toon in and out of my truck. I put duct tape over the seams and this helped.
2- With the motor mount offset to the right I had to use a longer shaft motor so I wouldn't hit the r/hand pontoon.
3- The valves will sometimes develope a slow leak ( not enough to worrie about in four hours of fishing ) I'm going to put o-rings or thin cork strips in the caps and see if that helps.
I learned alot from that toon to help me upgrade. I now use a fish cat cougar and like it alot.
If you have any questions ask away or p.m. me.
Rodger
p.s. If I can fix the valve problem, I will be selling it in april. That toon has many fish storys
[signature]