|
Spinning Gear for Tubes
|
05-08-2004, 03:45 PM
I'll let TD answer your other questions but yes you can save a ton of money building your own rods. Most of the time it's around half the cost. Or you can save less money and upgrade the components and really trick it out if you want. The trade off is the time you put in and if the rod breaks then you only get a new blank if it has a warranty and you have to build it over again.
FM [signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spinning Gear for Tubes - by TubeDude - 05-07-2004, 02:22 AM
Re: [TubeDude] Spinning Gear for Tubes - by Dryrod - 05-07-2004, 05:34 AM
Re: [Dryrod] Spinning Gear for Tubes - by TubeDude - 05-07-2004, 12:11 PM
Re: [TubeDude] Spinning Gear for Tubes - by LloydE - 05-08-2004, 02:11 PM
Re: [LloydE] Spinning Gear for Tubes - by fishmagnet - 05-08-2004, 03:45 PM
Re: [LloydE] Spinning Gear for Tubes - by TubeDude - 05-08-2004, 05:46 PM
Re: [TubeDude] Spinning Gear for Tubes - by LloydE - 05-08-2004, 08:47 PM
Re: [LloydE] Spinning Gear for Tubes - by TubeDude - 05-09-2004, 01:21 AM
Re: [TubeDude] Spinning Gear for Tubes - by Jedburton - 05-09-2004, 05:25 AM
Re: [Jedburton] Spinning Gear for Tubes - by TubeDude - 05-09-2004, 10:53 AM
Re: [TubeDude] Spinning Gear for Tubes - by Jedburton - 05-09-2004, 01:55 PM
|
