07-05-2022, 12:18 AM
(This post was last modified: 07-05-2022, 12:50 AM by Pennyfarmer2.)
I am a old member who just came back after about 12 years or so. 
I designed a 3d printed planer board. I currently only have a left one designed. It worked okay on Willard today but I think the wind and waves greatly affected it. I did catch a walleye on it.
I can provide the 3d model to anyone who wants it. I think the biggest issue is that it doesn't have much weight, I'm going to put a place to tape pennies in to tune the board. It requires two easy to get parts, a bicycle spoke and a bike inner tube.
I will also print and give out a couple if you don't have access to a printer.
https://www.instagram.com/p/CfnEk_HpDQom...MyMTA2M2Y=
![[Image: FB-IMG-1656977891198.jpg]](https://i.postimg.cc/vD0sXhPS/FB-IMG-1656977891198.jpg)
I designed a 3d printed planer board. I currently only have a left one designed. It worked okay on Willard today but I think the wind and waves greatly affected it. I did catch a walleye on it.
I can provide the 3d model to anyone who wants it. I think the biggest issue is that it doesn't have much weight, I'm going to put a place to tape pennies in to tune the board. It requires two easy to get parts, a bicycle spoke and a bike inner tube.
I will also print and give out a couple if you don't have access to a printer.
https://www.instagram.com/p/CfnEk_HpDQom...MyMTA2M2Y=