|
Ice sled 2.0
|
12-31-2019, 03:08 PM
No worries! for anyone who would like to, its 4 tee connectors, 2 elbows and 6 feet of 1-1/4" inside diameter pipe. I put six inch legs on the elbows and four inch pieces on the tee connectors. Then you have to cut 2 of the tees in half and on one of them you have to cut the legs off of it and shave a bit on the sides so that it will fit in-between the fins on the auger
[signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Ice sled 2.0 - by DjHill16 - 12-31-2019, 04:35 AM
Re: [DjHill16] Ice sled 2.0 - by 2knots - 12-31-2019, 12:29 PM
Re: [2knots] Ice sled 2.0 - by DjHill16 - 12-31-2019, 01:03 PM
Re: [DjHill16] Ice sled 2.0 - by 2knots - 12-31-2019, 01:19 PM
Re: [DjHill16] Ice sled 2.0 - by Paul_G - 12-31-2019, 03:00 PM
Re: [Paul_G] Ice sled 2.0 - by DjHill16 - 12-31-2019, 03:08 PM
Re: [DjHill16] Ice sled 2.0 - by r2u2 - 12-31-2019, 11:49 PM
|
