|
Ice Auger
|
11-05-2017, 11:21 PM
Question for you all. I recently purchased a Eskimo propane auger. I put it together and it runs fine. When I attach the auger the whole thing starts to wobble. Is this normal for a new power auger. Anyone know how to tell if it's the shaft on the motor side that's not square or the auger side? Should I take it back and just get a new one? Thanks in advance.
[signature] |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Ice Auger - by Jonzee - 11-05-2017, 11:21 PM
Re: [Jonzee] Ice Auger - by SkunkedAgain - 11-06-2017, 12:37 AM
Re: [SkunkedAgain] Ice Auger - by SkunkedAgain - 11-06-2017, 04:09 AM
Re: [SkunkedAgain] Ice Auger - by Jonzee - 11-06-2017, 04:56 PM
Re: [Jonzee] Ice Auger - by utwalleye - 11-06-2017, 02:59 PM
Re: [utwalleye] Ice Auger - by Jonzee - 11-06-2017, 05:00 PM
Re: [Jonzee] Ice Auger - by Hookinup - 11-06-2017, 05:26 PM
Re: [Jonzee] Ice Auger - by Dog-lover - 11-07-2017, 03:14 PM
Re: [Jonzee] Ice Auger - by utwalleye - 11-07-2017, 03:28 PM
|
