01-27-2017, 09:44 PM
[#0000FF]I have not made a camera stand but I have made several ice rod holders that use a tripod base. See attached pics. I suppose that since there is not a lot of weight involved you could use 90 degree "L" fittings instead of the angled ones...and make the width just right to fit your hole. Then you could make the riser just as long as needed for camera height.
Also, on my rod holders I do not glue or screw the connections for the tripod rods. I can then twist them out and pack everything up neatly...and bungee it together for compact transport.
Of course I would be happy to help you fab up a prototype if you want to bring your camera down sometime...along with the dimensions of the holes you drill.
[/#0000FF]
[signature]
Also, on my rod holders I do not glue or screw the connections for the tripod rods. I can then twist them out and pack everything up neatly...and bungee it together for compact transport.
Of course I would be happy to help you fab up a prototype if you want to bring your camera down sometime...along with the dimensions of the holes you drill.
[/#0000FF]
[signature]